top of page



Toolbox bus hinge



GROUP 214.003

  • The toolboxes in group 214.003 are made of stainless steel

  • The sheet thickness is 1.5 mm, fully matt

  • Each toolbox in group 214.003 is produced with aeration in the rear wall.

  • Full splash resistance is achieved through the design of the groove as a continuous chute.

  • A rubber seal has been placed on top of this, over which the lid closes.

  • The lid is fitted with stainless steel hinges.

  • The box is fitted with two stainless steel T-drop locks with espagnolette

  • This box has been specially developed for situations where there is little space around the vehicle.

Toolbox bus hinge
Toolbox bus hinge
bottom of page